EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP6RGZ-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP6RGZ-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*	Digi*
1789226187	173 Count	67 Count	67 Count
1789224387	172 Count	67 Count	67 Count
1789222586	171 Count	67 Count	67 Count
1789220785	170 Count	67 Count	67 Count
1789218984	169 Count	67 Count	67 Count
1789217184	168 Count	67 Count	67 Count
1789172190	143 Count	67 Count	67 Count
1789170390	142 Count	67 Count	67 Count
1789168589	141 Count	67 Count	67 Count
1789166788	140 Count	67 Count	67 Count
1789164987	139 Count	67 Count	67 Count
1789163187	138 Count	67 Count	67 Count
1789161386	137 Count	67 Count	67 Count
1789159585	136 Count	67 Count	67 Count
1789157784	135 Count	67 Count	67 Count
1789155984	134 Count	67 Count	67 Count
1789154183	133 Count	67 Count	67 Count
1789152382	132 Count	67 Count	67 Count
1789150592	131 Count	67 Count	67 Count
1789148791	130 Count	67 Count	67 Count
1789146990	129 Count	67 Count	67 Count
1789145189	128 Count	67 Count	67 Count
1789143389	127 Count	67 Count	67 Count
1789141588	126 Count	67 Count	67 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)