EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP6RGZ-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP6RGZ-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1788983179	970 Count	154 Count	138 Count
1788981379	969 Count	154 Count	138 Count
1788979578	968 Count	154 Count	138 Count
1788977783	967 Count	154 Count	138 Count
1788975982	966 Count	154 Count	138 Count
1788974182	965 Count	154 Count	138 Count
1788972381	964 Count	154 Count	138 Count
1788970580	963 Count	154 Count	138 Count
1788968779	962 Count	154 Count	138 Count
1788966979	961 Count	154 Count	138 Count
1788965178	960 Count	154 Count	138 Count
1788963377	959 Count	154 Count	138 Count
1788961576	958 Count	154 Count	138 Count
1788959776	957 Count	154 Count	138 Count
1788957975	956 Count	154 Count	138 Count
1788956181	955 Count	154 Count	138 Count
1788954381	954 Count	154 Count	138 Count
1788952580	953 Count	154 Count	138 Count
1788950779	941 Count	143 Count	127 Count
1788948978	940 Count	143 Count	127 Count
1788947178	939 Count	143 Count	127 Count
1788945377	938 Count	143 Count	127 Count
1788943576	937 Count	143 Count	127 Count
1788941776	936 Count	143 Count	127 Count
1788939975	935 Count	143 Count	127 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)