EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

F5MIW-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F5MIW-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*	Digi*
1789234712	272 Count	759 Count	254 Count
1789231108	260 Count	734 Count	243 Count
1789227504	249 Count	706 Count	233 Count
1789223900	240 Count	686 Count	225 Count
1789220320	228 Count	654 Count	214 Count
1789216716	217 Count	611 Count	204 Count
1789213112	196 Count	537 Count	184 Count
1789209507	186 Count	507 Count	175 Count
1789205903	175 Count	470 Count	165 Count
1789202299	147 Count	350 Count	138 Count
1789198728	136 Count	301 Count	128 Count
1789195124	120 Count	265 Count	113 Count
1789191519	105 Count	236 Count	99 Count
1789187915	92 Count	204 Count	87 Count
1789184311	77 Count	170 Count	73 Count
1789180707	62 Count	136 Count	59 Count
1789177120	46 Count	97 Count	44 Count
1789173515	30 Count	63 Count	29 Count
1789169910	15 Count	31 Count	15 Count
1789166306	470 Count	1032 Count	445 Count
1789162702	456 Count	997 Count	432 Count
1789159098	441 Count	965 Count	418 Count
1789155519	412 Count	908 Count	390 Count
1789151915	394 Count	875 Count	373 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)