EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

F5MIW-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F5MIW-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*	Digi*
1793054887	126 Count	418 Count	114 Count
1793051283	114 Count	394 Count	103 Count
1793047678	102 Count	373 Count	92 Count
1793044074	94 Count	353 Count	85 Count
1793041112	88 Count	337 Count	80 Count
1793037507	78 Count	312 Count	71 Count
1793033903	68 Count	290 Count	62 Count
1793030299	57 Count	262 Count	52 Count
1793026695	45 Count	158 Count	41 Count
1793023090	34 Count	118 Count	31 Count
1793019507	23 Count	80 Count	21 Count
1793015903	10 Count	39 Count	10 Count
1793012298	515 Count	1095 Count	484 Count
1793008694	455 Count	964 Count	425 Count
1793005090	439 Count	926 Count	410 Count
1793001486	425 Count	863 Count	398 Count
1792997294	411 Count	830 Count	385 Count
1792993689	393 Count	801 Count	368 Count
1792990085	376 Count	772 Count	352 Count
1792986481	354 Count	737 Count	331 Count
1792982877	333 Count	704 Count	311 Count
1792979272	312 Count	670 Count	291 Count
1792975695	293 Count	641 Count	273 Count
1792972091	272 Count	609 Count	253 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)