EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP2OSA-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2OSA-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1789237126	962 Count	147 Count	130 Count
1789236225	961 Count	147 Count	130 Count
1789235324	960 Count	147 Count	130 Count
1789234423	959 Count	147 Count	130 Count
1789233522	958 Count	147 Count	130 Count
1789232641	957 Count	147 Count	130 Count
1789231740	956 Count	147 Count	130 Count
1789230839	955 Count	147 Count	130 Count
1789229938	954 Count	147 Count	130 Count
1789229037	953 Count	147 Count	130 Count
1789228136	952 Count	147 Count	130 Count
1789227235	951 Count	147 Count	130 Count
1789226334	950 Count	147 Count	130 Count
1789225433	949 Count	147 Count	130 Count
1789224532	948 Count	147 Count	130 Count
1789223631	947 Count	147 Count	130 Count
1789222731	946 Count	147 Count	130 Count
1789221829	945 Count	147 Count	130 Count
1789220928	944 Count	147 Count	130 Count
1789220027	943 Count	147 Count	130 Count
1789219127	942 Count	147 Count	130 Count
1789218225	941 Count	147 Count	130 Count
1789217325	940 Count	147 Count	130 Count
1789216424	939 Count	147 Count	130 Count
1789215523	938 Count	147 Count	130 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)