EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP2OSA-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2OSA-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1789209240	931 Count	147 Count	130 Count
1789208339	930 Count	147 Count	130 Count
1789207437	929 Count	147 Count	130 Count
1789206537	928 Count	147 Count	130 Count
1789205636	927 Count	147 Count	130 Count
1789204735	926 Count	147 Count	130 Count
1789203834	925 Count	147 Count	130 Count
1789202933	924 Count	147 Count	130 Count
1789202032	910 Count	134 Count	117 Count
1789201131	898 Count	123 Count	106 Count
1789200230	897 Count	123 Count	106 Count
1789199329	896 Count	123 Count	106 Count
1789198428	895 Count	123 Count	106 Count
1789197528	894 Count	123 Count	106 Count
1789196627	893 Count	123 Count	106 Count
1789195726	892 Count	122 Count	106 Count
1789194825	891 Count	121 Count	106 Count
1789193924	890 Count	120 Count	106 Count
1789193023	889 Count	120 Count	106 Count
1789192122	888 Count	120 Count	106 Count
1789191221	887 Count	120 Count	106 Count
1789190320	886 Count	119 Count	106 Count
1789189440	885 Count	119 Count	106 Count
1789188539	884 Count	119 Count	106 Count
1789187638	883 Count	119 Count	106 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)