EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

F4FWW-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F4FWW-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*	Digi*
1789252677	93 Count	27 Count	22 Count
1789250876	92 Count	27 Count	22 Count
1789249076	91 Count	27 Count	22 Count
1789247275	90 Count	27 Count	22 Count
1789223882	77 Count	27 Count	22 Count
1789222081	76 Count	27 Count	22 Count
1789220280	75 Count	27 Count	22 Count
1789218479	74 Count	27 Count	22 Count
1789216679	73 Count	27 Count	22 Count
1789214878	72 Count	27 Count	22 Count
1789213077	71 Count	27 Count	22 Count
1789211277	70 Count	27 Count	22 Count
1789209476	58 Count	15 Count	11 Count
1789207675	51 Count	5 Count	5 Count
1789205874	50 Count	5 Count	5 Count
1789204074	49 Count	5 Count	5 Count
1789180680	31 Count	0 Count	0 Count
1789178880	30 Count	0 Count	0 Count
1789177079	29 Count	0 Count	0 Count
1789175278	28 Count	0 Count	0 Count
1789173478	27 Count	0 Count	0 Count
1789171677	26 Count	0 Count	0 Count
1789169876	25 Count	0 Count	0 Count
1789168076	24 Count	0 Count	0 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)