EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

F4FWW-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F4FWW-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1774174519	501 Count	386 Count	223 Count
1774172719	500 Count	386 Count	223 Count
1774170918	499 Count	386 Count	223 Count
1774169117	498 Count	385 Count	223 Count
1774167316	497 Count	385 Count	223 Count
1774165516	496 Count	383 Count	223 Count
1774163715	495 Count	382 Count	223 Count
1774161914	493 Count	381 Count	222 Count
1774160113	491 Count	379 Count	221 Count
1774158313	489 Count	378 Count	220 Count
1774156512	488 Count	378 Count	220 Count
1774154717	486 Count	377 Count	219 Count
1774152916	484 Count	376 Count	218 Count
1774151116	482 Count	374 Count	217 Count
1774149315	480 Count	372 Count	216 Count
1774147514	478 Count	371 Count	215 Count
1774145713	476 Count	369 Count	214 Count
1774143913	474 Count	368 Count	213 Count
1774142112	472 Count	367 Count	212 Count
1774140311	470 Count	365 Count	211 Count
1774138511	468 Count	363 Count	210 Count
1774136710	466 Count	362 Count	209 Count
1774134909	464 Count	360 Count	208 Count
1774133118	462 Count	358 Count	207 Count
1774131317	460 Count	357 Count	206 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)