EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

EB2BRA-15 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EB2BRA-15. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1789245863	25 Count	822 Count
1789244059	24 Count	791 Count
1789242256	23 Count	746 Count
1789240453	22 Count	715 Count
1789238649	21 Count	689 Count
1789236846	20 Count	646 Count
1789235083	19 Count	607 Count
1789233279	18 Count	573 Count
1789231476	17 Count	533 Count
1789229673	16 Count	493 Count
1789227869	15 Count	445 Count
1789226065	14 Count	419 Count
1789224262	13 Count	383 Count
1789222458	12 Count	354 Count
1789220655	11 Count	318 Count
1789218852	10 Count	289 Count
1789217048	9 Count	257 Count
1789215245	8 Count	225 Count
1789213482	7 Count	204 Count
1789211678	6 Count	180 Count
1789209875	5 Count	146 Count
1789208071	4 Count	122 Count
1789206268	3 Count	95 Count
1789204464	2 Count	73 Count
1789202661	1 Count	50 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)