EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

EB2BRA-15 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EB2BRA-15. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1794573458	32 Count	303 Count
1794571655	31 Count	280 Count
1794569851	30 Count	255 Count
1794568048	29 Count	232 Count
1794566286	28 Count	189 Count
1794564482	27 Count	164 Count
1794562679	26 Count	142 Count
1794560875	25 Count	123 Count
1794559072	24 Count	121 Count
1794557269	23 Count	119 Count
1794555465	22 Count	117 Count
1794553661	21 Count	114 Count
1794551857	20 Count	112 Count
1794550054	19 Count	110 Count
1794548251	18 Count	108 Count
1794546447	17 Count	106 Count
1794544684	16 Count	104 Count
1794542881	15 Count	102 Count
1794541077	14 Count	100 Count
1794539274	13 Count	98 Count
1794537471	12 Count	96 Count
1794535667	11 Count	94 Count
1794533864	10 Count	92 Count
1794532061	9 Count	89 Count
1794530257	8 Count	87 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)