EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

MB7USU-5 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object MB7USU-5. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1773655836	530 Count	599 Count	281 Count
1773654036	528 Count	597 Count	280 Count
1773652235	526 Count	595 Count	279 Count
1773650443	524 Count	593 Count	278 Count
1773648642	522 Count	591 Count	277 Count
1773646842	520 Count	589 Count	276 Count
1773645041	518 Count	587 Count	275 Count
1773643240	516 Count	585 Count	274 Count
1773641439	514 Count	583 Count	273 Count
1773639639	512 Count	581 Count	272 Count
1773637838	510 Count	579 Count	271 Count
1773636038	508 Count	577 Count	270 Count
1773634237	506 Count	575 Count	269 Count
1773632436	504 Count	573 Count	268 Count
1773630636	502 Count	572 Count	267 Count
1773628842	500 Count	570 Count	266 Count
1773627041	498 Count	569 Count	265 Count
1773625241	496 Count	567 Count	264 Count
1773623440	494 Count	565 Count	263 Count
1773621639	492 Count	564 Count	262 Count
1773619839	490 Count	562 Count	261 Count
1773618038	488 Count	560 Count	260 Count
1773616237	486 Count	558 Count	259 Count
1773614437	484 Count	556 Count	258 Count
1773612636	482 Count	554 Count	257 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)