EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

MB7USU-5 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object MB7USU-5. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1790484575	7 Count	9 Count	6 Count
1790482774	3 Count	5 Count	3 Count
1790480974	981 Count	1001 Count	898 Count
1790479173	977 Count	997 Count	895 Count
1790477380	973 Count	994 Count	892 Count
1790475579	970 Count	990 Count	890 Count
1790473778	965 Count	986 Count	887 Count
1790471977	960 Count	982 Count	883 Count
1790470177	956 Count	978 Count	880 Count
1790468376	952 Count	974 Count	877 Count
1790466576	948 Count	970 Count	874 Count
1790464775	944 Count	966 Count	871 Count
1790462974	939 Count	960 Count	867 Count
1790461173	936 Count	957 Count	865 Count
1790459373	932 Count	954 Count	862 Count
1790457572	928 Count	950 Count	859 Count
1790455784	924 Count	946 Count	856 Count
1790453984	919 Count	941 Count	852 Count
1790452183	915 Count	937 Count	849 Count
1790450382	911 Count	933 Count	846 Count
1790448581	885 Count	905 Count	821 Count
1790446781	872 Count	891 Count	809 Count
1790444979	800 Count	811 Count	738 Count
1790443179	792 Count	803 Count	731 Count
1790441378	737 Count	747 Count	677 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)