EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ2CPA-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ2CPA-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1789215992	797 Count	275 Count	209 Count
1789214191	794 Count	273 Count	207 Count
1789212390	791 Count	271 Count	205 Count
1789210590	787 Count	268 Count	202 Count
1789208789	784 Count	266 Count	200 Count
1789206989	781 Count	264 Count	198 Count
1789205188	777 Count	261 Count	195 Count
1789203387	774 Count	259 Count	193 Count
1789201586	772 Count	258 Count	192 Count
1789199793	771 Count	258 Count	192 Count
1789197992	770 Count	258 Count	192 Count
1789196192	769 Count	258 Count	192 Count
1789194391	768 Count	258 Count	192 Count
1789192590	767 Count	258 Count	192 Count
1789190790	766 Count	258 Count	192 Count
1789188989	765 Count	258 Count	192 Count
1789187188	764 Count	258 Count	192 Count
1789185387	763 Count	258 Count	192 Count
1789183587	762 Count	258 Count	192 Count
1789181786	761 Count	258 Count	192 Count
1789179985	760 Count	258 Count	192 Count
1789178192	759 Count	258 Count	192 Count
1789156592	747 Count	258 Count	192 Count
1789154791	746 Count	258 Count	192 Count
1789152991	745 Count	258 Count	192 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)