EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ2CPA-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ2CPA-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1785102321	71 Count	558 Count
1785100520	70 Count	546 Count
1785098719	69 Count	538 Count
1785096919	68 Count	530 Count
1785095118	67 Count	522 Count
1785093317	66 Count	514 Count
1785091524	65 Count	506 Count
1785089723	64 Count	498 Count
1785087923	63 Count	491 Count
1785086122	62 Count	483 Count
1785084321	61 Count	475 Count
1785082521	60 Count	467 Count
1785080720	59 Count	459 Count
1785078919	58 Count	451 Count
1785077119	57 Count	443 Count
1785075318	56 Count	435 Count
1785073517	55 Count	429 Count
1785071717	54 Count	421 Count
1785069926	53 Count	414 Count
1785068125	52 Count	406 Count
1785066324	51 Count	398 Count
1785064523	50 Count	390 Count
1785062723	49 Count	382 Count
1785060922	48 Count	374 Count
1785059121	47 Count	366 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)