EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

PA3GPU-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object PA3GPU-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1751595205	136 Count	948 Count
1751593402	135 Count	946 Count
1751591598	134 Count	944 Count
1751589794	133 Count	942 Count
1751587991	132 Count	940 Count
1751586223	131 Count	938 Count
1751584419	130 Count	936 Count
1751582616	129 Count	934 Count
1751580813	128 Count	932 Count
1751579009	127 Count	930 Count
1751577206	126 Count	928 Count
1751575403	125 Count	926 Count
1751573599	124 Count	925 Count
1751571795	123 Count	923 Count
1751569992	122 Count	921 Count
1751568189	121 Count	919 Count
1751566385	120 Count	917 Count
1751564621	119 Count	915 Count
1751562818	118 Count	914 Count
1751561015	117 Count	912 Count
1751559211	116 Count	910 Count
1751557408	115 Count	908 Count
1751555604	114 Count	906 Count
1751553801	113 Count	889 Count
1751551998	112 Count	888 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)