EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SR2INO-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR2INO-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1751606110	69 Count	868 Count	37 Count
1751604310	68 Count	847 Count	37 Count
1751602509	67 Count	828 Count	37 Count
1751600709	66 Count	807 Count	37 Count
1751598907	65 Count	779 Count	37 Count
1751589909	60 Count	654 Count	37 Count
1751588108	59 Count	614 Count	37 Count
1751586307	58 Count	588 Count	37 Count
1751584507	57 Count	562 Count	37 Count
1751582706	56 Count	536 Count	37 Count
1751580905	55 Count	510 Count	37 Count
1751579105	54 Count	479 Count	37 Count
1751577304	53 Count	447 Count	37 Count
1751575504	52 Count	423 Count	37 Count
1751573703	51 Count	399 Count	37 Count
1751571902	50 Count	377 Count	37 Count
1751570102	49 Count	352 Count	37 Count
1751568307	43 Count	323 Count	32 Count
1751566506	30 Count	290 Count	20 Count
1751564706	22 Count	264 Count	13 Count
1751562905	21 Count	239 Count	13 Count
1751561105	18 Count	213 Count	11 Count
1751559304	15 Count	179 Count	9 Count
1751557504	13 Count	148 Count	8 Count
1751555703	10 Count	118 Count	6 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)