EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SR2INO-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR2INO-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1751535901	69 Count	749 Count	58 Count
1751534100	66 Count	658 Count	56 Count
1751532300	65 Count	626 Count	56 Count
1751530499	64 Count	603 Count	56 Count
1751528699	63 Count	573 Count	56 Count
1751526898	49 Count	515 Count	43 Count
1751525107	39 Count	445 Count	34 Count
1751523306	6 Count	289 Count	2 Count
1751521506	3 Count	221 Count	0 Count
1751519705	2 Count	174 Count	0 Count
1751517904	1 Count	111 Count	0 Count
1751516103	0 Count	56 Count	0 Count
1751514303	18 Count	1043 Count	0 Count
1751512502	17 Count	984 Count	0 Count
1751510701	16 Count	942 Count	0 Count
1751508900	15 Count	884 Count	0 Count
1751507100	14 Count	827 Count	0 Count
1751505299	13 Count	771 Count	0 Count
1751503496	12 Count	714 Count	0 Count
1751501695	11 Count	643 Count	0 Count
1751499895	10 Count	590 Count	0 Count
1751498093	9 Count	534 Count	0 Count
1751496293	8 Count	480 Count	0 Count
1751494492	7 Count	429 Count	0 Count
1751492692	6 Count	372 Count	0 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)