EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

EA4ATS-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EA4ATS-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1765060817	4 Count	460 Count
1765059014	3 Count	357 Count
1765057210	2 Count	258 Count
1765055406	1 Count	172 Count
1765053638	0 Count	86 Count
1765051834	14 Count	1003 Count
1765050031	13 Count	905 Count
1765048227	12 Count	752 Count
1765046424	11 Count	708 Count
1765044620	10 Count	643 Count
1765042816	9 Count	593 Count
1765041013	8 Count	527 Count
1765039209	7 Count	470 Count
1765037406	6 Count	423 Count
1765035636	5 Count	364 Count
1765033832	4 Count	302 Count
1765032029	3 Count	237 Count
1765030225	2 Count	188 Count
1765028422	1 Count	131 Count
1765026618	0 Count	80 Count
1765024814	14 Count	1005 Count
1765021207	12 Count	896 Count
1765019404	11 Count	846 Count
1765019162	10 Count	846 Count
1765017358	9 Count	786 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)