EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

F6JON-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F6JON-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1789064109	51 Count	459 Count	20 Count
1789062343	50 Count	442 Count	20 Count
1789060540	49 Count	425 Count	20 Count
1789058737	47 Count	414 Count	19 Count
1789056934	46 Count	403 Count	19 Count
1789055131	45 Count	395 Count	19 Count
1789053328	44 Count	388 Count	19 Count
1789051525	43 Count	371 Count	19 Count
1789049722	42 Count	358 Count	19 Count
1789047919	34 Count	337 Count	12 Count
1789046116	31 Count	324 Count	10 Count
1789044312	28 Count	310 Count	8 Count
1789042509	25 Count	297 Count	6 Count
1789040740	18 Count	282 Count	0 Count
1789038937	17 Count	273 Count	0 Count
1789037134	16 Count	261 Count	0 Count
1789035331	15 Count	251 Count	0 Count
1789033528	14 Count	240 Count	0 Count
1789031725	13 Count	231 Count	0 Count
1789029922	12 Count	224 Count	0 Count
1789028119	11 Count	213 Count	0 Count
1789026316	10 Count	199 Count	0 Count
1789024513	9 Count	185 Count	0 Count
1789022710	8 Count	172 Count	0 Count
1789020907	7 Count	160 Count	0 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)