EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ2ODE-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ2ODE-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1767317493	465 Count	71 Count
1767315693	464 Count	71 Count
1767313892	463 Count	71 Count
1767312091	462 Count	71 Count
1767310297	461 Count	71 Count
1767308497	460 Count	71 Count
1767306696	459 Count	71 Count
1767304896	458 Count	71 Count
1767303095	457 Count	71 Count
1767299493	455 Count	71 Count
1767297693	454 Count	71 Count
1767295892	453 Count	71 Count
1767294091	452 Count	71 Count
1767292291	451 Count	71 Count
1767290490	450 Count	71 Count
1767288696	449 Count	71 Count
1767286896	448 Count	71 Count
1767285095	447 Count	71 Count
1767283294	446 Count	71 Count
1767281494	445 Count	71 Count
1767279693	444 Count	71 Count
1767277893	443 Count	71 Count
1767276092	442 Count	71 Count
1767274291	441 Count	71 Count
1767272491	440 Count	71 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)