EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP5UID Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP5UID. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*
1792624925	5 Count	288 Count
1792621324	4 Count	216 Count
1792617727	3 Count	165 Count
1792614126	2 Count	96 Count
1792610524	1 Count	57 Count
1792606923	0 Count	0 Count
1792603325	7 Count	946 Count
1792599724	6 Count	854 Count
1792596124	5 Count	759 Count
1792592523	4 Count	413 Count
1792588924	3 Count	172 Count
1792585322	2 Count	130 Count
1792581724	1 Count	83 Count
1792578122	0 Count	52 Count
1792574523	9 Count	1036 Count
1792570922	8 Count	990 Count
1792567323	7 Count	911 Count
1792563722	6 Count	866 Count
1792560123	5 Count	787 Count
1792556522	4 Count	699 Count
1792552922	3 Count	593 Count
1792549320	2 Count	455 Count
1792545721	1 Count	319 Count
1792542119	0 Count	170 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)