EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP5XTF-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP5XTF-3. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1781503130	985 Count	558 Count	448 Count
1781501329	984 Count	558 Count	448 Count
1781499529	982 Count	557 Count	447 Count
1781497728	981 Count	557 Count	447 Count
1781495927	978 Count	555 Count	445 Count
1781494127	976 Count	554 Count	444 Count
1781492326	974 Count	552 Count	443 Count
1781490525	973 Count	551 Count	443 Count
1781488725	971 Count	550 Count	442 Count
1781486924	970 Count	550 Count	442 Count
1781485123	969 Count	550 Count	442 Count
1781483323	968 Count	550 Count	442 Count
1781481529	966 Count	549 Count	441 Count
1781479728	964 Count	547 Count	440 Count
1781477927	963 Count	547 Count	440 Count
1781476127	961 Count	545 Count	439 Count
1781474326	959 Count	543 Count	438 Count
1781472526	957 Count	542 Count	437 Count
1781470725	956 Count	542 Count	437 Count
1781468924	954 Count	540 Count	436 Count
1781467124	952 Count	539 Count	435 Count
1781465323	951 Count	539 Count	435 Count
1781463523	949 Count	537 Count	434 Count
1781461722	948 Count	537 Count	434 Count
1781459928	946 Count	536 Count	433 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)