EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP9LJE-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP9LJE-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1780165689	951 Count	960 Count	752 Count
1780163889	950 Count	960 Count	752 Count
1780162088	949 Count	960 Count	752 Count
1780160287	948 Count	960 Count	752 Count
1780158487	944 Count	953 Count	751 Count
1780156686	940 Count	952 Count	751 Count
1780154886	937 Count	950 Count	751 Count
1780153085	934 Count	948 Count	751 Count
1780151292	929 Count	948 Count	751 Count
1780149491	907 Count	928 Count	731 Count
1780147691	904 Count	928 Count	731 Count
1780145890	900 Count	926 Count	731 Count
1780144089	897 Count	923 Count	731 Count
1780142289	891 Count	917 Count	728 Count
1780140488	888 Count	915 Count	728 Count
1780138688	885 Count	913 Count	728 Count
1780136887	882 Count	912 Count	728 Count
1780135087	879 Count	909 Count	728 Count
1780133286	877 Count	908 Count	728 Count
1780131485	876 Count	908 Count	728 Count
1780129690	874 Count	907 Count	727 Count
1780127889	835 Count	869 Count	689 Count
1780126089	803 Count	838 Count	658 Count
1780124288	795 Count	831 Count	651 Count
1780122487	794 Count	831 Count	651 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)