EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SP5UID-4 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP5UID-4. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1764005607	1 Count	94 Count
1764003806	0 Count	46 Count
1764002004	11 Count	1020 Count
1764000203	10 Count	926 Count
1763998401	9 Count	870 Count
1763996600	8 Count	714 Count
1763994799	7 Count	661 Count
1763992997	6 Count	465 Count
1763991196	5 Count	400 Count
1763989395	4 Count	356 Count
1763987593	3 Count	297 Count
1763985792	2 Count	249 Count
1763983991	1 Count	146 Count
1763982189	0 Count	73 Count
1763980388	14 Count	1029 Count
1763978587	13 Count	968 Count
1763976786	12 Count	880 Count
1763974984	11 Count	829 Count
1763973183	10 Count	785 Count
1763971381	9 Count	724 Count
1763969580	8 Count	660 Count
1763967779	7 Count	587 Count
1763965977	6 Count	518 Count
1763964176	5 Count	415 Count
1763962375	4 Count	266 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)