EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SP5UID-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP5UID-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1767296194	42 Count	1005 Count
1767294393	41 Count	980 Count
1767292592	40 Count	950 Count
1767290795	39 Count	923 Count
1767288994	38 Count	889 Count
1767287193	37 Count	863 Count
1767285392	36 Count	789 Count
1767283595	35 Count	730 Count
1767281793	34 Count	695 Count
1767279992	33 Count	665 Count
1767278191	32 Count	628 Count
1767276394	31 Count	599 Count
1767274593	30 Count	567 Count
1767272792	29 Count	536 Count
1767270991	28 Count	489 Count
1767269193	27 Count	422 Count
1767267392	26 Count	383 Count
1767265592	25 Count	354 Count
1767263790	24 Count	325 Count
1767261994	23 Count	294 Count
1767260192	22 Count	261 Count
1767258391	21 Count	221 Count
1767256590	17 Count	172 Count
1767254793	3 Count	119 Count
1767252992	2 Count	86 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)