EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP5UID-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP5UID-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1779043988	7 Count	409 Count
1779042187	6 Count	365 Count
1779040385	5 Count	315 Count
1779038592	4 Count	267 Count
1779036790	3 Count	214 Count
1779034989	2 Count	166 Count
1779033188	1 Count	115 Count
1779031389	0 Count	68 Count
1779029588	26 Count	1017 Count
1779027786	25 Count	970 Count
1779025985	24 Count	917 Count
1779024189	23 Count	886 Count
1779022388	22 Count	840 Count
1779020586	21 Count	796 Count
1779018785	20 Count	754 Count
1779016990	19 Count	715 Count
1779015188	18 Count	662 Count
1779013386	17 Count	615 Count
1779011585	16 Count	557 Count
1779009789	15 Count	513 Count
1779007988	14 Count	478 Count
1779006186	13 Count	429 Count
1779004385	12 Count	404 Count
1779002588	11 Count	378 Count
1779000787	10 Count	351 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)