EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SP9LJE-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP9LJE-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1762354538	86 Count	94 Count	81 Count
1762352737	75 Count	83 Count	71 Count
1762350936	63 Count	70 Count	60 Count
1762349136	40 Count	48 Count	38 Count
1762347335	28 Count	37 Count	27 Count
1762345535	10 Count	19 Count	10 Count
1762343742	342 Count	1011 Count	313 Count
1762341941	331 Count	994 Count	303 Count
1762340141	317 Count	975 Count	290 Count
1762338340	306 Count	965 Count	280 Count
1762336539	295 Count	954 Count	270 Count
1762334739	285 Count	943 Count	261 Count
1762332938	274 Count	931 Count	251 Count
1762331137	263 Count	911 Count	241 Count
1762329337	251 Count	890 Count	230 Count
1762327536	239 Count	837 Count	219 Count
1762325735	227 Count	798 Count	208 Count
1762323935	206 Count	690 Count	188 Count
1762322141	193 Count	615 Count	176 Count
1762320340	180 Count	546 Count	164 Count
1762318540	167 Count	483 Count	152 Count
1762316739	156 Count	426 Count	142 Count
1762314938	144 Count	370 Count	131 Count
1762313138	133 Count	327 Count	121 Count
1762311337	120 Count	269 Count	109 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)