EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

EA8EE-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EA8EE-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1753947134	778 Count	581 Count	581 Count
1753945331	774 Count	578 Count	578 Count
1753943528	770 Count	575 Count	575 Count
1753941725	766 Count	572 Count	572 Count
1753939922	762 Count	569 Count	569 Count
1753938118	758 Count	566 Count	566 Count
1753936315	754 Count	563 Count	563 Count
1753934512	750 Count	560 Count	560 Count
1753932709	746 Count	557 Count	557 Count
1753930906	742 Count	554 Count	554 Count
1753929140	738 Count	551 Count	551 Count
1753927337	734 Count	548 Count	548 Count
1753925534	730 Count	545 Count	545 Count
1753923731	726 Count	542 Count	542 Count
1753921928	722 Count	539 Count	539 Count
1753920125	718 Count	536 Count	536 Count
1753918321	714 Count	533 Count	533 Count
1753916518	710 Count	530 Count	530 Count
1753914715	706 Count	527 Count	527 Count
1753912912	702 Count	524 Count	524 Count
1753911109	698 Count	521 Count	521 Count
1753909306	694 Count	518 Count	518 Count
1753885939	643 Count	480 Count	480 Count
1753884136	639 Count	477 Count	477 Count
1753882333	635 Count	474 Count	474 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)