EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SP5UID-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP5UID-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1767295789	11 Count	407 Count
1767293988	10 Count	376 Count
1767292186	9 Count	350 Count
1767290385	8 Count	318 Count
1767288588	7 Count	291 Count
1767286787	6 Count	259 Count
1767284986	5 Count	172 Count
1767283184	4 Count	122 Count
1767281389	3 Count	96 Count
1767279587	2 Count	60 Count
1767277786	1 Count	28 Count
1767275985	0 Count	0 Count
1767274187	45 Count	968 Count
1767272386	44 Count	930 Count
1767270584	43 Count	888 Count
1767268783	42 Count	819 Count
1767266988	41 Count	785 Count
1767265186	40 Count	754 Count
1767263385	39 Count	724 Count
1767261584	38 Count	693 Count
1767259787	37 Count	665 Count
1767257985	36 Count	615 Count
1767256184	26 Count	570 Count
1767254382	16 Count	520 Count
1767252586	15 Count	490 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)