EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SP5UID-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP5UID-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1766358780	30 Count	980 Count
1766356978	29 Count	938 Count
1766355178	28 Count	891 Count
1766353377	27 Count	855 Count
1766351576	26 Count	814 Count
1766349774	25 Count	811 Count
1766347979	24 Count	785 Count
1766346177	23 Count	730 Count
1766344376	22 Count	681 Count
1766342575	21 Count	620 Count
1766340792	20 Count	578 Count
1766338991	19 Count	532 Count
1766337190	18 Count	521 Count
1766335389	17 Count	507 Count
1766333578	16 Count	493 Count
1766331777	15 Count	485 Count
1766329975	14 Count	464 Count
1766328174	13 Count	450 Count
1766326377	12 Count	432 Count
1766324576	11 Count	421 Count
1766322774	10 Count	419 Count
1766320973	9 Count	393 Count
1766319177	8 Count	344 Count
1766317376	7 Count	292 Count
1766315575	6 Count	274 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)