EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SR2JP-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR2JP-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1767315873	154 Count	404 Count
1767314192	153 Count	402 Count
1767312511	152 Count	397 Count
1767310830	151 Count	395 Count
1767309147	150 Count	392 Count
1767307469	149 Count	389 Count
1767305788	148 Count	386 Count
1767302426	146 Count	378 Count
1767300745	145 Count	374 Count
1767297635	139 Count	368 Count
1767295951	138 Count	366 Count
1767294270	137 Count	364 Count
1767292592	136 Count	361 Count
1767290909	135 Count	355 Count
1767285866	132 Count	347 Count
1767284185	131 Count	344 Count
1767282503	130 Count	339 Count
1767280825	129 Count	336 Count
1767279144	128 Count	335 Count
1767276028	122 Count	332 Count
1767274350	121 Count	330 Count
1767272669	120 Count	328 Count
1767270988	119 Count	325 Count
1767269307	118 Count	317 Count
1767267624	117 Count	315 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)