EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SR2JP-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR2JP-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1791236553	6 Count	24 Count
1791234872	247 Count	1022 Count
1791233191	241 Count	998 Count
1791231510	236 Count	970 Count
1791229829	230 Count	951 Count
1791228148	223 Count	930 Count
1791226468	216 Count	910 Count
1791224787	211 Count	891 Count
1791223106	203 Count	869 Count
1791221425	198 Count	848 Count
1791218313	183 Count	806 Count
1791216632	177 Count	783 Count
1791214951	172 Count	763 Count
1791213270	166 Count	745 Count
1791211590	154 Count	720 Count
1791209909	148 Count	692 Count
1791208228	142 Count	660 Count
1791206547	136 Count	636 Count
1791204866	129 Count	613 Count
1791203186	122 Count	589 Count
1791201505	115 Count	540 Count
1791199824	108 Count	511 Count
1791196717	94 Count	451 Count
1791195036	87 Count	434 Count
1791193355	83 Count	409 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)