EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

LW2DHT-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object LW2DHT-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1783400471	284 Count	267 Count	212 Count
1783398668	279 Count	262 Count	208 Count
1783395062	268 Count	252 Count	199 Count
1783393294	257 Count	245 Count	193 Count
1783391491	252 Count	239 Count	189 Count
1783384278	231 Count	210 Count	172 Count
1783382475	226 Count	205 Count	168 Count
1783380672	222 Count	201 Count	165 Count
1783378869	218 Count	197 Count	162 Count
1783377066	214 Count	193 Count	159 Count
1783375263	209 Count	188 Count	155 Count
1783373460	205 Count	183 Count	152 Count
1783369888	190 Count	173 Count	143 Count
1783368084	185 Count	168 Count	139 Count
1783366281	179 Count	161 Count	134 Count
1783364478	175 Count	157 Count	131 Count
1783360872	168 Count	151 Count	126 Count
1783359070	163 Count	146 Count	122 Count
1783357266	159 Count	142 Count	119 Count
1783355463	154 Count	137 Count	115 Count
1783353660	149 Count	132 Count	111 Count
1783348286	128 Count	116 Count	97 Count
1783344679	117 Count	106 Count	88 Count
1783342875	111 Count	99 Count	83 Count
1783341072	106 Count	94 Count	79 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)