EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SR2WH-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR2WH-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1770824766	106 Count	361 Count	101 Count
1770822965	91 Count	319 Count	87 Count
1770821164	77 Count	280 Count	74 Count
1770819364	61 Count	192 Count	59 Count
1770817563	37 Count	84 Count	36 Count
1770813962	422 Count	1068 Count	403 Count
1770812161	388 Count	999 Count	370 Count
1770810361	362 Count	941 Count	345 Count
1770808560	346 Count	887 Count	330 Count
1770806759	312 Count	809 Count	297 Count
1770804958	295 Count	769 Count	281 Count
1770803158	277 Count	742 Count	264 Count
1770801357	250 Count	683 Count	238 Count
1770799556	233 Count	632 Count	222 Count
1770797756	203 Count	556 Count	193 Count
1770795955	178 Count	492 Count	169 Count
1770794154	151 Count	398 Count	143 Count
1770792382	103 Count	308 Count	100 Count
1770790581	75 Count	232 Count	73 Count
1770788780	54 Count	159 Count	53 Count
1770786980	25 Count	77 Count	25 Count
1770785179	398 Count	1049 Count	387 Count
1770783379	372 Count	977 Count	362 Count
1770781578	345 Count	911 Count	336 Count
1770779777	308 Count	823 Count	300 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)