EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SR2CA-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR2CA-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1765100690	45 Count	405 Count
1765099009	44 Count	389 Count
1765097328	43 Count	378 Count
1765094211	37 Count	358 Count
1765092530	36 Count	346 Count
1765090849	35 Count	335 Count
1765089169	34 Count	322 Count
1765087488	33 Count	307 Count
1765085807	32 Count	297 Count
1765084126	31 Count	286 Count
1765082445	30 Count	275 Count
1765080765	29 Count	260 Count
1765079084	28 Count	244 Count
1765077403	27 Count	232 Count
1765075722	26 Count	222 Count
1765072625	20 Count	201 Count
1765070944	19 Count	189 Count
1765069264	18 Count	178 Count
1765067583	17 Count	166 Count
1765065895	16 Count	151 Count
1765064214	15 Count	140 Count
1765062533	14 Count	128 Count
1765060852	13 Count	117 Count
1765059172	12 Count	108 Count
1765057491	11 Count	92 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)