EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SR2DTW-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR2DTW-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1789219820	61 Count	249 Count	38 Count
1789218139	57 Count	240 Count	35 Count
1789216458	53 Count	223 Count	32 Count
1789214777	49 Count	204 Count	29 Count
1789213097	47 Count	190 Count	28 Count
1789211416	43 Count	181 Count	25 Count
1789209735	38 Count	169 Count	21 Count
1789208054	34 Count	165 Count	18 Count
1789206374	30 Count	161 Count	15 Count
1789204693	26 Count	154 Count	12 Count
1789203012	22 Count	148 Count	9 Count
1789201331	20 Count	140 Count	8 Count
1789199899	14 Count	132 Count	7 Count
1789198219	12 Count	123 Count	6 Count
1789196538	10 Count	113 Count	5 Count
1789194857	8 Count	106 Count	4 Count
1789193176	6 Count	96 Count	3 Count
1789191496	5 Count	79 Count	3 Count
1789189815	3 Count	61 Count	2 Count
1789188134	1 Count	30 Count	1 Count
1789186453	86 Count	1015 Count	39 Count
1789184773	82 Count	987 Count	36 Count
1789183092	79 Count	960 Count	34 Count
1789181411	77 Count	945 Count	33 Count
1789179730	75 Count	910 Count	32 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)