EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SR2DTW-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR2DTW-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1785815013	327 Count	493 Count	37 Count
1785813332	326 Count	490 Count	37 Count
1785811652	324 Count	483 Count	36 Count
1785809971	322 Count	477 Count	35 Count
1785808539	317 Count	473 Count	35 Count
1785806858	315 Count	468 Count	34 Count
1785805177	314 Count	465 Count	34 Count
1785803497	312 Count	460 Count	33 Count
1785801816	310 Count	455 Count	32 Count
1785800135	308 Count	448 Count	31 Count
1785798454	307 Count	443 Count	31 Count
1785796774	305 Count	436 Count	30 Count
1785795093	303 Count	430 Count	29 Count
1785793412	301 Count	417 Count	28 Count
1785791731	299 Count	412 Count	27 Count
1785790051	298 Count	409 Count	27 Count
1785788370	296 Count	402 Count	26 Count
1785786938	291 Count	400 Count	26 Count
1785785257	290 Count	399 Count	26 Count
1785783576	289 Count	398 Count	26 Count
1785781896	288 Count	395 Count	26 Count
1785780215	287 Count	393 Count	26 Count
1785778534	286 Count	391 Count	26 Count
1785776853	285 Count	388 Count	26 Count
1785775172	284 Count	385 Count	26 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)