EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

S51ZK-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object S51ZK-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*	Digi*
1762370257	141 Count	907 Count	131 Count
1762366654	130 Count	830 Count	121 Count
1762363051	118 Count	742 Count	110 Count
1762359466	108 Count	667 Count	101 Count
1762355862	84 Count	586 Count	78 Count
1762352259	67 Count	492 Count	62 Count
1762348656	57 Count	412 Count	53 Count
1762345053	46 Count	339 Count	43 Count
1762341450	36 Count	269 Count	34 Count
1762337865	25 Count	183 Count	24 Count
1762334262	9 Count	92 Count	9 Count
1762330659	169 Count	1054 Count	154 Count
1762327056	159 Count	954 Count	145 Count
1762323452	148 Count	874 Count	135 Count
1762319849	137 Count	791 Count	125 Count
1762316265	122 Count	721 Count	111 Count
1762312662	112 Count	662 Count	102 Count
1762309058	102 Count	601 Count	93 Count
1762305455	91 Count	542 Count	83 Count
1762301852	80 Count	480 Count	73 Count
1762298249	69 Count	415 Count	63 Count
1762294664	58 Count	347 Count	53 Count
1762291061	45 Count	287 Count	41 Count
1762287458	34 Count	219 Count	31 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)