EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

S51ZK-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object S51ZK-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*	Digi*
1761826638	55 Count	609 Count	48 Count
1761823035	48 Count	550 Count	42 Count
1761819450	41 Count	502 Count	36 Count
1761815847	32 Count	431 Count	28 Count
1761812243	22 Count	340 Count	19 Count
1761808640	13 Count	266 Count	11 Count
1761805037	5 Count	166 Count	4 Count
1761801434	0 Count	0 Count	0 Count
1761797850	177 Count	931 Count	160 Count
1761794247	167 Count	882 Count	151 Count
1761790643	160 Count	843 Count	145 Count
1761787040	146 Count	790 Count	132 Count
1761783437	132 Count	740 Count	119 Count
1761779834	120 Count	690 Count	108 Count
1761776252	110 Count	640 Count	99 Count
1761772648	97 Count	595 Count	87 Count
1761769045	87 Count	552 Count	78 Count
1761765442	71 Count	501 Count	63 Count
1761761839	62 Count	438 Count	55 Count
1761758235	49 Count	384 Count	43 Count
1761754648	43 Count	338 Count	38 Count
1761751045	29 Count	292 Count	25 Count
1761747442	20 Count	241 Count	17 Count
1761743839	15 Count	119 Count	13 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)