EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

F4BQN-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F4BQN-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1772088261	863 Count	774 Count	774 Count
1772087357	854 Count	766 Count	766 Count
1772086453	846 Count	759 Count	759 Count
1772085550	838 Count	752 Count	752 Count
1772084646	831 Count	746 Count	746 Count
1772083742	821 Count	737 Count	737 Count
1772082839	812 Count	729 Count	729 Count
1772081935	804 Count	722 Count	722 Count
1772081031	796 Count	715 Count	715 Count
1772080127	789 Count	709 Count	709 Count
1772079223	779 Count	700 Count	700 Count
1772078319	773 Count	695 Count	695 Count
1772077415	763 Count	686 Count	686 Count
1772076512	756 Count	680 Count	680 Count
1772075608	747 Count	672 Count	672 Count
1772074704	740 Count	666 Count	666 Count
1772073801	729 Count	656 Count	656 Count
1772072897	722 Count	650 Count	650 Count
1772071993	711 Count	640 Count	640 Count
1772071090	705 Count	635 Count	635 Count
1772070290	698 Count	629 Count	629 Count
1772069386	689 Count	621 Count	621 Count
1772068483	681 Count	614 Count	614 Count
1772067579	673 Count	607 Count	607 Count
1772066675	666 Count	601 Count	601 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)