EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP3QDU-15 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP3QDU-15. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1794632282	414 Count	13 Count
1794631382	413 Count	13 Count
1794630481	412 Count	13 Count
1794629580	411 Count	13 Count
1794628679	410 Count	13 Count
1794627778	409 Count	13 Count
1794626878	408 Count	13 Count
1794625977	407 Count	13 Count
1794625076	406 Count	13 Count
1794624175	405 Count	13 Count
1794623274	404 Count	13 Count
1794622373	403 Count	13 Count
1794621473	402 Count	13 Count
1794620572	401 Count	13 Count
1794619671	400 Count	13 Count
1794618770	399 Count	13 Count
1794617869	398 Count	13 Count
1794616988	393 Count	13 Count
1794616087	392 Count	13 Count
1794615186	391 Count	13 Count
1794614285	390 Count	13 Count
1794613384	389 Count	13 Count
1794612483	388 Count	13 Count
1794611582	387 Count	13 Count
1794610682	386 Count	13 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)