EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

GM4ISM-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object GM4ISM-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1792742313	60 Count	385 Count	52 Count
1792740511	53 Count	341 Count	46 Count
1792738707	46 Count	294 Count	40 Count
1792736904	39 Count	266 Count	34 Count
1792735101	32 Count	242 Count	28 Count
1792733298	25 Count	200 Count	22 Count
1792731533	18 Count	138 Count	16 Count
1792729730	11 Count	90 Count	10 Count
1792727927	4 Count	43 Count	4 Count
1792726124	170 Count	1030 Count	148 Count
1792724321	162 Count	990 Count	141 Count
1792722518	155 Count	941 Count	135 Count
1792720714	148 Count	890 Count	129 Count
1792718911	140 Count	838 Count	122 Count
1792717108	133 Count	792 Count	116 Count
1792715305	127 Count	749 Count	111 Count
1792713501	120 Count	698 Count	105 Count
1792711698	113 Count	643 Count	99 Count
1792709933	106 Count	617 Count	93 Count
1792708130	98 Count	572 Count	86 Count
1792704524	87 Count	494 Count	77 Count
1792702721	82 Count	462 Count	73 Count
1792700918	76 Count	422 Count	68 Count
1792699116	70 Count	387 Count	63 Count
1792697312	64 Count	342 Count	58 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)