EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ2WIT-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ2WIT-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1791135572	21 Count	59 Count	20 Count
1791134671	9 Count	25 Count	9 Count
1791133771	648 Count	1029 Count	591 Count
1791132870	631 Count	994 Count	575 Count
1791131969	612 Count	956 Count	557 Count
1791131069	592 Count	913 Count	538 Count
1791130168	578 Count	882 Count	525 Count
1791129267	563 Count	851 Count	511 Count
1791128367	552 Count	826 Count	501 Count
1791127466	537 Count	798 Count	487 Count
1791126565	526 Count	777 Count	477 Count
1791125680	509 Count	755 Count	465 Count
1791124779	497 Count	735 Count	454 Count
1791123879	484 Count	716 Count	442 Count
1791122978	468 Count	694 Count	427 Count
1791122077	437 Count	653 Count	397 Count
1791121176	423 Count	634 Count	384 Count
1791120275	406 Count	607 Count	368 Count
1791119375	383 Count	578 Count	346 Count
1791118474	360 Count	546 Count	324 Count
1791117573	350 Count	533 Count	315 Count
1791116673	330 Count	507 Count	296 Count
1791115772	310 Count	478 Count	277 Count
1791114871	298 Count	456 Count	266 Count
1791113971	290 Count	445 Count	259 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)