EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

3Z2T-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object 3Z2T-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*	Value4*	Value5*
1755523812	137	690	412	256
1755522012	135	677	412	256
1755520213	133	671	412	256
1755518413	131	665	412	256
1755516612	129	658	410	256
1755514813	127	633	410	256
1755513013	125	626	410	256
1755511214	123	618	410	256
1755509414	121	609	411	256
1755507613	119	597	411	255
1755505813	117	590	411	218
1755504014	115	582	410	218
1755502214	113	575	410	219
1755500416	111	566	410	218
1755498615	109	541	409	218
1755496816	107	525	409	218
1755495017	105	519	409	218
1755493216	103	511	409	219
1755491417	101	503	409	219
1755489617	99	493	409	154
1755487818	97	483	409	80
1755486019	95	474	408	50
1755484220	93	464	409	50
1755482420	91	455	409	50
1755480621	89	446	409	50

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)