EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP2HCC-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2HCC-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1789720510	50 Count	118 Count	47 Count
1789719009	39 Count	95 Count	37 Count
1789717508	20 Count	51 Count	19 Count
1789716007	7 Count	23 Count	7 Count
1789714506	560 Count	1271 Count	525 Count
1789699447	439 Count	988 Count	405 Count
1789697946	429 Count	964 Count	396 Count
1789696445	417 Count	937 Count	385 Count
1789694944	407 Count	912 Count	376 Count
1789693443	396 Count	886 Count	366 Count
1789691942	385 Count	859 Count	356 Count
1789690441	374 Count	833 Count	346 Count
1789688940	365 Count	808 Count	338 Count
1789687439	326 Count	726 Count	300 Count
1789685939	304 Count	676 Count	279 Count
1789684438	294 Count	652 Count	270 Count
1789682937	282 Count	625 Count	259 Count
1789681436	273 Count	597 Count	251 Count
1789679935	264 Count	575 Count	243 Count
1789678433	254 Count	553 Count	234 Count
1789677846	249 Count	540 Count	230 Count
1789676345	239 Count	519 Count	221 Count
1789674844	217 Count	484 Count	203 Count
1789673343	199 Count	452 Count	186 Count
1789671842	190 Count	432 Count	178 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)