EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

IT9IRS-TP Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IT9IRS-TP. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1792838121	474 Count	895 Count	109 Count
1792837877	473 Count	893 Count	109 Count
1792837633	472 Count	891 Count	109 Count
1792837388	470 Count	888 Count	108 Count
1792837144	469 Count	883 Count	108 Count
1792836899	468 Count	878 Count	108 Count
1792836654	467 Count	875 Count	108 Count
1792836410	465 Count	873 Count	107 Count
1792835921	462 Count	863 Count	106 Count
1792835677	461 Count	861 Count	106 Count
1792835433	459 Count	858 Count	105 Count
1792835188	458 Count	856 Count	105 Count
1792834944	457 Count	855 Count	105 Count
1792834699	456 Count	855 Count	105 Count
1792834455	455 Count	852 Count	105 Count
1792834363	450 Count	851 Count	105 Count
1792834119	449 Count	847 Count	105 Count
1792833875	448 Count	844 Count	105 Count
1792833630	446 Count	839 Count	104 Count
1792833385	445 Count	837 Count	104 Count
1792833141	444 Count	836 Count	104 Count
1792832897	443 Count	835 Count	104 Count
1792832652	442 Count	830 Count	104 Count
1792832407	441 Count	823 Count	104 Count
1792832163	439 Count	818 Count	103 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)