EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

IT9IRS-PA Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IT9IRS-PA. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1792833610	0 Count	17 Count
1792833013	62 Count	1017 Count
1792831198	59 Count	925 Count
1792829980	57 Count	884 Count
1792829383	56 Count	873 Count
1792828778	55 Count	843 Count
1792828174	54 Count	829 Count
1792826360	51 Count	780 Count
1792825755	50 Count	769 Count
1792825150	49 Count	752 Count
1792824538	48 Count	731 Count
1792823933	47 Count	705 Count
1792823329	46 Count	686 Count
1792822724	45 Count	662 Count
1792822127	44 Count	649 Count
1792821522	43 Count	638 Count
1792820910	42 Count	622 Count
1792820305	41 Count	605 Count
1792819700	40 Count	586 Count
1792819096	39 Count	567 Count
1792818490	38 Count	547 Count
1792817885	37 Count	529 Count
1792817288	36 Count	506 Count
1792816676	35 Count	487 Count
1792815474	33 Count	446 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)